atmega328 on a breadboard on arduino 1.8.5 not showing up

Or you can compile with a newer version of the IDE (up to 1.8.13 have been tested), but after you open the IDE, go to the Tools menu and select Board->Boards Manager.

Compile with Arduino IDE 1.8.5 ( the download can be found here).

In both cases you are still going to compile for the Arduino Nano (in the IDE select Tools -> Board -> Arduino AVR Boards -> Arduino Nano). Therefore, to be successful you have two options. If the wrong version is used, it will compile with global memory usage over 90%, with the warning 'Low memory available, stability problems may occur.' And indeed, stability problems will occur. Compiling Firmwareįor reasons that were never fully identified, this project will only compile with certain versions of the Arduino IDE. Leave your Arduino attached to your computer with a USB cable and open the Serial Monitor from within the Arduino IDE to see informational messages printed during operation. You can also set the device to send repair signals, and you can even have the device respond by sending a repair signal whenever it receives a 'hit' - this would be useful for a static tank 'repair station.' Recoil servo end points and retract and return times can all be adjusted in this file, as well as which protocols are sent and which are received. Several configuration settings are available in the 'A_Setup.h' file (it will appear as a tab in your sketch). You can attach a recoil servo to pin D8 and a Taigen High Intensity flash to D6 and they will also activate whenever the cannon is fired.

Whenever positive 5 volts is detected on pin A0, for example a signal from another device.

Whenever pin D4 is connected to ground, for example with a pushbutton.

IR can be sent ('cannon fire') in two ways: With the addition of an IR receiver and emitter this sketch can send and receive any RC tank protocol. (In the Arduino IDE, go to the Tools menu and under the Board section select 'Arduino Nano' or 'Arduino AVR Boards -> Arduino Nano') The files in the TankIR folder consist of an Arduino sketch that can be loaded onto any Arduino Duemilanove/Uno/Nano or other board with an ATmega328 processor.

Atmega328 on a breadboard on arduino 1.8.5 not showing up